QubicaAMF XLi Pinspotter Motor and Gearbox Manual
400-088-038 40 Revision F
12. Insert the rotor assembly into the frame and guide the upper bearing into the recess in the upper end
bell. Ensure that the upper bearing is seated within the recess. Use the mallet to seat the bearing, if
necessary.
13. With both the upper and lower end bells firmly against the motor frame and being careful not to pinch
any of the motor’s wiring, secure them in place with the four long bolts. Tighten securely.
14. Rotate the motor’s shaft to verify that there is no binding. The back end motor is ready to be reinstalled
in the back end gearbox.
To Previous Page
Loading...