..... Next, the canopy mounted to the fuselage is turned over and the
aft canopy bulkhead fitted into position. The aft face should be
located a maximum of 1/8" forward of the forward face of the Seatback
Bulkhead with a few dabs of 5-MIN. It is permanently mounted with
flox and 2 BID tapes on either side, lapping onto the bulk head and
fuselage a minimum of 1.5 inches, and lapping onto the canopy a
minimum of 0.7 inches.
..... Also, sand down the lip in the inside fuselage skin lamination
and contour the inside fuselage skin smoothly into the canopy. Then
To Next Page