Pivots - metal tube bushings in wood. Loose fit on
nails. The 1/8" dia. brass tube available at hobby
shops is excellent for the bushings. MUST BE
FRICTION FREE.
These ratios result in a 43-part hardener to
100-part resin mix.
RATIO BALANCE FOR RESIN/HARDENER
1. Place both empty cups as shown (wet
the hardener cup).
2. Adjust ballast weight to level mark.
3. Fill resin cup with desired amount of
resin 1 to 6 oz.
4. Add hardener to hardener cup to
balance scale on level mark.
5. Pour the hardener into the resin cup
and mix.
Hot Wire Cutter
..... You will need a hot wire cutter to carve all the foam cores for
the canard, vertical fin, and wing. Refer to sketch.
To Next Page
Loading...