Quickie Q2 - Page 53

To Next Page

To Previous Page

.....Using a small hone, grind the cutting edges of your drill bit flat

as shown (not undercut). This will keep the drill from grabbing into the

glass. Don't over-do it, just make a couple of light passes with the

hone.

.....In several places rough, cured glass surfaces occur where overlaps

or thick buildups are done. These rough edges should be smoothed as shown

using a grinder or sanding block.

.....The Dremel (Moto Tool) or Home Shop (Weller) is a very versatile

tool with many uses in the construction of your Q2. The kits usually have

a nice selection of bits, cutters, grinders, stones, and mandrels for

every conceivable use. The three types of bits shown here are the most

useful for your project. Don't throw the others out, as your next door