Quicksilver Activ 755 Sundeck User Manual

Quicksilver 755SD — System & Component Overview and Operaon
21
Macerator
The macerator gives the boat operator the means of discharging the holding tank directly
overboard through a seacock in the boom of the hull. The macerator controls are located next to
the main baery panel located in the center a storage box. Since direct overboard discharge is
prohibited in many areas, the macerator seacock is normally closed.
To Operate the Macerator:
1. Make sure the macerator seacock is in the open posion.
2. Press and hold the macerator switch located on the main baery panel. The macerator
switch is a momentary switch, which means that it needs to be held in the “ON” posion
during operaon.
3. When the tank is empty, release the macerator switch.
4. Return the macerator seacock to the closed posion.
Toilet Operaon
Macerator Switch Locaon
Macerator switch
Rotate the interior step so that the toilet
will not hit it when sliding into the
operaonal posion.
Using the notch in the board, slide the
toilet out from the storage posion.
Avoid inadvertent discharge of the black water system.
Always keep the macerator seacock closed when not in use.

Quicksilver Activ 755 Sundeck Specifications

General

Brand	Quicksilver
Model	Activ 755 Sundeck
Category	Boat
Language	English