www.quikoitaly.com
MEASURES TO BE RESPECTED / MISURE DA RISPETTARE / MESURES A RESPECTER:
-------------------------------------------------------------------------------------------------------------------------------------------------------------
DECLARATION OF CONFORMITY
(OF THE MANUFACTURER)
Manufacturer: QUIKO ITALY
Via Seccalegno, 19
36040 Sossano (VI)
Italia
hereby declares, under his liability, that products: QK-E400 / QK-E400FX / QK-E400B
are in compliance with the esse
l safety requirements of the re
• Electro-magne
c bility .........................2004/108/EC
• Low Voltage D
......................................................2006/95/EC
• Machinery Dir
.........................................................2006/42/EC
and their amendments and modifica
ns, and with the reg set forth by the
onal Body of the country in which the machinery is des ned for use.
Sossano, 01/01/2016
A
B
Managing Director
Luca Borinato
MIN / MAX A AND B MEASURES
max 1122mm
MAX. DISTANCE BETWEEN BRACKETS
PUSH TO OPEN SOLUTION
If necessary, when PUSH TO OPEN installation is required,
extending the bracket on the pillar, it is possible to install the
motor internally and let the gate open externally as per the
image below:
To Previous Page
Loading...
