SAFETY INSTRUCTIONS
Our products have been carefully designed and tested to
ensure your baby’s safety and comfort. Complies with
safety requirements - Tested in an approved laboratory
in accordance with order no. 91-1292 - December 1991
- EN1888:2012.
This vehicle is intended for children from 0 months 1.
and up to 15 kg.
Never carry more than 1 child per place in the 2.
pushchair at a time.
Never lift the pushchair with the child inside it.3.
If the manufacturer of your pushchair recommends 4.
using it in combination with a carrycot or a car seat,
then, the maximum weight for the combination is that
indicated on the additional product.
If the manufacturer of your pushchair recommends 5.
using it in combination with a carrycot or car seat,
always have them facing you.
Never use stairs or escalators with your child in the 6.
pushchair.
Always use the most recline position when used for 7.
new born babies.
The brake must always be on when putting the child in 8.
or taking him out. Always use the parking brake, even
when standing still for only a few moments!
Only use accessories or spare parts sold or approved 9.
by the manufacturer. Using other accessories could
be dangerous.
For buggies with accessories (depending on the 10.
version), please respect the maximum weight loads
indicated below: Ex : Maximum permitted weight for
the play tray 2 kg. Maximum permitted weight for
the net bag 2 kg. Maximum permitted weight for the
storage pocket 1 kg. Maximum permitted weight for
the basket 2kg.
CLEANING AND MAINTENANCE
• Maintain and clean the Quinny Moodd frequently.
• Take care while cleaning the Quinny Moodd. Clean the
frame and plastic parts of the pushchair with a damp
cloth and mild detergent and dry thoroughly. Don’t use
abrasive cleaners on either the plastic section or the
frame or bleach near the fabric covers otherwise this
may cause discoloration or scratches.
• When it is raining, always use the raincover to protect
the fabric cover.
• After using in the rain, wipe the pushchair with a soft,
absorbent cloth.
• Remove the detachable wheels once a month. Clean the
axles and treat them with a dry Teon spray. Never use
Vaseline, grease or silicon lubricants.
• Inate the rear tyres to a maximum pressure of 26 psi
/ 1.8 bar. The tyres are tted with a ‘car tyre valve’. They
can be inated using the pump supplied (in shopping
bag). The valves on the rear wheels can be easily
accessed from the inside of the wheel.
• A punctured inner tube can be repaired in the same way
as a bicycle tyre. Spare inner tubes can be purchased
through your supplier.
• Always deate the tyres when taking the Moodd on an
aircraft, as the air pressure difference could cause the
tyres to burst.
• The brakes may require periodic adjustment. To do this,
use two 8 mm spanners to unlock the lock nut from the
long barrel nut. Adjust the brake cable and retighten the
lock nut. Test the brakes to ensure a positive engagement
and disengagement after adjustment.
WASTE SEPARATION
To help protect the environment, we kindly ask you to
separate the packaging waste from the Quinny Moodd and
at the end of its useful life to separate the components and
dispose it properly.
To Next Page
Loading...
