Qvis TERMINATOR G620 User Manual

© Copyright Qvis Labs. All soware and documentation rights reserved.
Manual updated February 2016
56
System Events
Within this menu secon you can set
whether you want the system to log an
event or send a nocaon email if a
hard disk drive has failed or has been
removed, or if an IP camera has gone
oine. Tick the boxes for the desired
setup and select ‘Accept Changes’ to
save setup.
Moon Alarm
Specify which cameras you want to
have the moon detecon funcon
enabled, and at what moon
sensivity level. When alarm is
triggered and camera’s video panel
enlarges to full screen on the monitor,
the le will stay full unl either the
user dismisses it or another alarm
occurs.
Relay Sengs
If you have acvated the relay(s) then
you can set the duraon of the relay
being opened when an alarm has
been triggered. Input a length of me
between 10-300 seconds, and then
select ‘Accept Changes’ to implement
the inpued length of me.
Audible Alarm
If you have selected ‘Audible Alarm’
on the ‘Sensor Events’ (see page 54)
opons then you can set the duraon
of the alarm being sounded when
an alarm has been triggered. Input
a length of me between 10-900
seconds, and then select ‘Accept
Changes’ to implement the inpued
length of me.
Alarm (connued)
Sengs

Qvis TERMINATOR G620 Specifications

General

Brand	Qvis
Model	TERMINATOR G620
Category	DVR
Language	English