How to fix R.P.S. Corporation Floor Machine when the unit does not power on?
If your R.P.S. Corporation Floor Machine doesn't power on, ensure the charger plug is firmly in the wall and the circuit breaker isn't blown. Check the 'EZlamp' indicator when plugged in to see if any LEDs light up. You might also try a different power cord. If these steps fail, the charger may need replacing.
What to do if R.P.S. Corporation Floor Machine is flashing RED & YELLOW?
If the R.P.S. Corporation Floor Machine is flashing red and yellow, it could be due to a poor connection or a battery problem. Check all connections and make sure the battery wasn't disconnected during charging. Also, inspect the battery and verify electrolyte levels if it's a lead-acid battery.
Why is the R.P.S. Corporation Floor Machine continuously flashing RED?
If your R.P.S. Corporation Floor Machine has a continuous red flashing light, check the battery connections. The issue might be due to no connection to the battery or the battery being connected in reverse.
What to do if the R.P.S. Corporation Scrubber timer has expired?
If the timer expires during any of the charge cycle modes, it indicates a potential issue with the battery set that requires user intervention. This can occur due to a damaged battery cell, an unusually high ambient temperature at the charger, or another external fault preventing the charge cycle from completing. To resolve this, power down the charger, disconnect it from the battery to reset the fault condition. After resolving the external problem, reconnect the charger output cable and the AC power.
General| Brand | R.P.S. Corporation |
|---|---|
| Model | MAGNUM series |
| Category | Scrubber |
| Language | English |
Explains how to navigate the manual and outlines its main sections.
Covers safety guidelines, operational procedures, and maintenance information.
Outlines the scope of warranty, exclusions, and conditions for claims.
Key safety guidelines for operating the unit and before leaving it.
Safety procedures to follow before operating or servicing the machine.
Important warnings covering electrical hazards, battery gases, and chemical safety.
Instructions for correctly connecting the machine's batteries.
Instructions for installing disk pad drivers and brushes.
A list of checks to perform before starting machine operation.
Explains common error codes and provides solutions for the control system.
Covers more error codes and their associated troubleshooting steps.
Provides in-depth explanations and correction procedures for various fault codes.
Additional fault codes and their solutions for the control system.
Addresses problems with power, brush/vacuum motors, and solution flow.
Troubleshooting for no solution flow and more water recovery problems.
To Next Page
