24
support.R82.org
ENGLISH
Safety
Signs, symbols and instructions placed on this product must never be covered or removed and must
remain present and clearly legible throughout the entire lifetime of the product. Immediately replace or
repair illegible or damaged signs, symbols and instructions. Contact your local dealer for instructions.
Caregiver
• Read the “User Guide” carefully before use
and keep it for future reference. Incorrect
use of this product may cause serious injury
to the user
• Always use the correct lifting techniques
and aids for this purpose
• Never leave the user unattended in this
product. Ensure permanent supervision by
an adult
• Repair/replacements must only be made
using new original R82 spare parts and t-
tings and carried out in accordance with the
guidelines and service intervals prescribed
by the supplier
• If there is any doubt as to the continued
safe use of your R82 product or if any parts
should fail, stop using the product immedi-
ately and contact your local dealer as soon
as possible
• Information about transportation can be
found in the document “Transportation in
Motor Vehicles” supplied with the product
Environment
• Observe the surface temperature on the
product, before placing an user in it. This
goes especially for users with insensitive
skin as they cannot feel the heat. If the sur-
face temperature is above 41°C then allow
the product to cool before use
• Use this product on a level surface without
any obstacles. Be aware of reduced maneu-
verability on slippery surfaces
• When using on inclines, please refer to mea-
surements
User
• If the user is close to the max. load limit
and/or has a lot of involuntary movements,
e.g. rocking, a larger size with a higher max.
load or a different R82 product should be
considered
Product
• Carry out all positional adjustments on the
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of
the reach of children
• Activate the brakes before placing the user
into the product
• Ensure the stability of the product is main-
tained before placing the user in it
• We recommend you notify the user before
angling the back
• Ensure the castors are fully-functional and
secure before use
• Inspect the product and all of its accesso-
ries and replace any worn out parts before
use
• Be careful not to get your ngers squeezed
• This product is tested for resistance to igni-
tion at level non-ignition in accordance with
EN 1021-1, EN 1021-2 and ISO 7176-16
• The product might lose its ame resistant
characteristics if using other than original
R82 cushions
• The plugs needs to be mounted in the slots
placed on each side of the Cricket when
accessories are not mounted in the slots.
• Shopping net need to be emptied before
folding the Cricket
Environmental conditions
• Operating temperature: -10°C to +40°C
• Relative humidity: 5% to 90%
• Atmospheric pressure: 800 to 1060 hPa
EN