Raco Verbatim - Verbatim Series DFP Autodialer; Analog Signal Input

Contents
iv Verbatim Owner's Manual
B.1.3 Programming the Input Signal Type ............................................. B-2
B.1.4 Programming the Scaling and Offset Factors ................................ B-3
B.1.5 Additional Perspective on Scaling Factors .................................... B-4
B.1.6 Programming High and Low Analog Setpoints ............................ B-8
B.1.7 Summary of Analog Programming Codes .................................... B-9
B.1.8 Recording Speech Messages for Analog Channels ....................... B-9
B.1.9 If Analog Inputs Do Not Work Correctly.................................... B-11
B.1.10 Troubleshooting Analog Grounding Problems
For Verbatim Analog ................................................................... B-11
C Remote Supervisory Control Output
C.1 Remote Supervisory Control (VRSC) Output Installation
and Operation Instructions ............................................................ C-1
C.1.1 Mounting and Wiring Connections for Remote Supervisor
Control ........................................................................................... C-1
RSC Supervisory Remote Control Output Box Diagram ............... C-2
C.1.2 Optional Direct Connection Without Use of Output Relay
Enclosure ....................................................................................... C-3
C.1.3 Remote Supervisory Control Operation ........................................ C-3
D Printer Options
D.1 Local Data Logger (Local Printer) Option .................................... D-1
D.1.1 Serial Printer Interface ................................................................... D-1
D.1.2 Parallel Printer Interface ................................................................ D-1
D.1.3 Time and Date Setting ................................................................... D-2
D.1.4 Printout at Regular Intervals .......................................................... D-2
E Data Acquisition/Central Data Logging
E.1 Return To Normal (RTN) Calling ................................................. E-1
E.2 Quick Intercall Delay & SCADA Units Connected to Cellular
Phones............................................................................................ E-2
E.3 Acknowledgment Calls To The SCADA Central Station ............. E-3
E.4 Modem Automatic Speed Select for SCADA Units ..................... E-4
E.5 Modem High Speed or Low Speed Selection................................ E-4
E.6 Number of Data Call Attempts Before Tripping a
Communications Alarm................................................................. E-5
E.7 Answer Mode - VOICE ONLY or
DATA-TO-VOICE ........................................................................ E-5
E.8 DATA/VOICE Autocall Calls for SCADA &
Central Data Logger ...................................................................... E-6