Raddy RF760 - Menu, Clock, and Dial Operations; Mode Selection

RF760 Full-Band Radio
13
11.1 Set time operation: In the shutdown state, long press [SET] for
two seconds and then short press [SET] and short press “ , ” to
start the clock setting (refer to details in 8.1).
11.2 Under the power-on state, start functions of the main menu
(refer to Operation Introduction 14 for details)
11.3 In WX band, long press [SET] to activate ALERT alarm and the
"SCAN" symbol flashes. Long press [SET] again to exit the Alert
function.
Note: SCAN indicates that WX is in the state of silent detection of
NOAA Alert state. If there is an Alert signal, sound or alarm will be
given out.
13.1 In power-on state, press [SET] to start the main menu and short
press [MODE] to select and switch corresponding sub-menu
functions.
13.2 In short wave (SW) & super-high frequency (VHF) & aviation
(AIR) band, non-menu mode; short press [MODE] key to switch
meter band functions.
13.2.1 In the short-wave (SW) receiving state, short press
[MODE] to switch the meter band, and the frequency points are:
3.20000MHZ, 3.75000MHZ, 3.90000MHZ, 4.75000MHZ,
5.73000MHZ, 7.10000MHZ, 9.25000MHZ, 11.50000MHZ,
13.57000MHZ, 15.03000MHZ, 17.48000MHZ, 18.90000MHZ,
21.45000MHZ, 25.67000MHZ.
11. Operation for menu/clock setting [SET]:
12. Rotary [flying shuttle] button:
Power-on state: Rotate the flying shuttle to adjust frequency display bit
values. When values are adjusted, the corresponding " " flashes. Short
press [STEP] to select the needed STEP value. Rotate the flying shuttle to
quickly select the desired frequency points.
13. Mode selection [MODE]: