Need help?Do you have a question about the Radical Sportscars SR3 XX and is the answer not in the manual?
General| Brand | Radical Sportscars |
|---|---|
| Model | SR3 XX |
| Category | Automobile |
| Language | English |
Details the layout and function of cockpit controls and steering wheel buttons.
Identifies engine bay components and details front suspension layouts.
Details rear suspension, electrical hardware locations, and PDM status.
Details the PDM status window, its lights, and the function of each output.
Shows the location of the reverse lever and explains its engagement procedure.
Essential checks to perform before taking the car to the track.
Explains car starting, paddleshift system, and gear engagement.
Details how to adjust the brake bias for optimal performance in different conditions.
Provides usage notes and checks for the optional Spin Safe Clutch system.
Instructions on how to adjust the driver's seat and pedals for optimal fit.
Step-by-step guide for initial track sessions to bed brakes and check systems.
Detailed steps for bedding in new brake discs to ensure heat stabilization.
Suggested cold and hot starting pressures for Hankook slick and wet tires.
Methods for analyzing tire behavior using temperature, pressure, and visual feedback.
Instructions on how to safely raise and lower the car using the air jack system.
Identifies correct jacking and lifting points for maintenance and track extraction.
A detailed guide on how to perform a base setup on the SR3 on a flat patch.
Explains corner weight importance and how to adjust for optimal balance.
Factory recommended setup sheet for Hankook tires, including camber, toe, and pressures.
Data for measuring front and rear drop heights relative to chassis height.
Details rebound and bump compression adjustments on the Intrax dampers.
Specific setup changes for optimal performance in wet track conditions.
Instructions for changing engine oil, oil filter, fuel filter, and air filter.
Correctly setting up the gearshift actuator to prevent damage and ensure smooth shifting.
Guide to setting up and verifying wheel speed sensors using a jig.
Procedure for ensuring throttle bodies open evenly and setting the TPS.
Illustrates the correct connection order for the ignition coil leads.
Step-by-step guide for changing gear ratios and servicing the GDU.
Instructions on how to properly fill the GDU with the correct amount of oil.
Procedure for checking and adjusting the Spin Safe Clutch system.
Inspection procedure for starter motor and idler gear damage after a spin.
Guide on how to program and set up the Tire Pressure Monitoring System (TPMS) sensors.
Flowchart and steps to diagnose and resolve engine non-starting problems.
Guide to identifying and fixing problems related to the car's charging system.
Steps to diagnose and fix problems with downshifts, neutral, and upshifts.
Diagram illustrating the layout and components of the dry sump lubrication system.
Diagrams showing torque specifications for engine and gear drive unit components.
Exploded views and torque settings for front and rear suspension parts.
Diagrams of brake system parts with associated torque specifications.
Comprehensive table of torque specifications for drive systems, suspension, and engine.
Key engine parameters and their target operating values.
List of commonly used parts with their descriptions and part numbers.
Details on required fluids, brands, capacities, and viscosity for the SR3.
Table of available gear ratios, part numbers, and corresponding speed data.
Reference for front and rear anti-roll bar sizes, materials, and part numbers.
Guidance on component lifespan and recommended service intervals.
Instructions for cleaning and re-greasing driveshafts every 10 hours of running.
Supplier recommendations for replacing seals in the brake calipers.
Comprehensive checklist for preparing the car before a race or test session.
To Next Page