...ESC THROTTLE RANGE CALIBRATION CONTINUED
PROGRAMMING YOUR ESC...
8
Reaktor Brushless Power Systems
By Radient RC
5. Without touching the trigger, press button to set the neutral position, GREEN LED
will flash 1 time.
6. Pull/hold full throttle, press the button again, release the trigger, GREEN LED will
flash 2 times.
7. Push/hold full brake/reverse, press the button again, GREEN LED will flash 3 times.
Release trigger.
8. Switch ESC OFF and back ON to complete setup.
9. Check the ESC operation to ensure forward throttle is actually forward, if not, switch
any two of the motor wires and re-check. Then repeat steps 3-8.
The Radient Reaktor is a programmable ESC. Although the default settings should work well
for most users, these settings exist so that you can fine tune the performance of your ESC
to your experience and components. It’s various programmable parameters can be adjusted
either by interfacing with the ESC directly button presses and counting LED flashes, or
via the optional Reaktor Program Box (RDNA0031) which includes a digital readout of the
settings for easier interpretation and faster setup. There are 6 programmable items for your
consideration, below are descriptions of each Item and following is the table and program-
ming instructions for choosing your settings should you choose to change from default
(highlighted in BOLD text).
NOTE: The most important of these settings is the Low Voltage Cut-Off Threshold
(Item 3). Please read the description and usage scenarios below to better under-
stand how to use this feature.
To Next Page
Loading...
Need help?
General
