9
...PROGRAMMING YOUR ESC CONTINUED...
Simple • Capable • Safe
Item 1: Running Mode:
1. Forward/Brake: This setting is considered as “Race” mode where the reverse function
is disabled.
2. Forward/Reverse-Brake: This setting is useful for normal operation since it allows for
using reverse throttle to back out of a stuck situation.
a. WARNING: switching from REVERSE to FORWARD throttle position quickly
will cause excess load on the electronics and drivetrain of your vehicle. It
is recommended to come to a stop before changing REVERSE/FORWARD
direction.
Item 2: Drag Brake Force (Automatic Brake):
1. 0%: This setting allows the vehicle to continue to roll after letting off throttle without
applying automatic-brake
2. 5%: Adding some drag brake will make the vehicle a little easier to control, especially
when driving on a closed circuit type course, helping you to slow down and make
turns easier.
3. 10%: Add more until you find the right balance of assistance with slowing down while
still being able to maintain good corner speed without upsetting the vehicle.
4. 15%
5. 20%
6. 25%
7. 30%
8. 40%
Item 3: Low Voltage Cut-Off (LVC) Threshold:
The Reaktor ESC has 6 built in LVC options. It is essential that you use the proper LVC setting
for the type of battery that your are using to achieve the optimal performance and safest
operation from your ESC/Motor/Battery. This setting should be chosen based on the number
and type of cells you are using. For LiPo batteries we recommend setting LVC to #5, using
a setting lower than this may cause over discharge of some batteries and cause damage to
your battery, which could lead to a fire.
1. No Protection: ONLY to be used with NiMH or NiCd type batteries. Since your vehicle
comes equipped with an 8 cell NiMH battery, we have set this mode as the default. The
ESC will run as long as possible, draining all possible energy from the batteries and
eventually your vehicle will cease to function properly.
a. When you notice the operation of your vehicle change, it is time to STOP run-
ning and re-charge your battery.
To Next Page
Loading...
Need help?
General
