Radio Shack 2000649 / PRO-649 - Understanding the Keypad; Turning Off the Key Tone

10 11
– Signal Stalker II.
PSE (Pause) – Stop and restart a search or tune.
– Search the preprogrammed marine bank.
–Searchthepreprogrammedre/policebank.
– Search the preprogrammed aircraft bank.
– Search the preprogrammed amateur radio bank.
–Searchthepreprogrammedweatherbank,orhold
tojumptotheSkywarnchannel.(First,programyourlocal
Skywarnfrequencyintochannel200).
SCAN / MAN (Manual) – Press to scan programmed
channels. Press again to monitor a single channel.
  – Select the direction for searching and scanning.
PRI / ALERT–Setthepriorityfeature,orsetSAME
standby mode when monitoring a weather channel.
0–9–Inputnumbersorselectbanks(0selectsbank10).
Thenumberrangeabovethekeys(1–20,21–40,41-60,
etc.)indicatesthechannelsstoredinthatbank.
• / DELAY – Input a decimal point or set a channel delay.
ENT (Enter) – Complete the entry of a frequency.
L/O
/
L/O RV W – Lock-out selected channels or
frequencies. Review locked-out frequencies.
TUNE / CLEAR – Enter Tune search. Clear an incorrect
entry.
PGM – Program frequencies into channels.
–Locks(andunlocks)thekeypadtoprevent
accidentalentries;turnsthebacklightonando.
Understanding the Keypad
Turning O the Key Tone
The scanner is preset to sound a tone each time you
press one of its keys.
To turn the key tone on and o:
1. Turn on the scanner. WELCOME SCAnnInG
rECEIVEr appears.
2. Whilethewelcomemessageisonthescreen,
press 1 to turn on the key tone or press 2 to turn
ito.