5
MOUNTING THE STATIONS
To mount a station on the wall, you need two screws (not
supplied) with heads that fit into the keyhole slots on the
bottom of the stations.
Follow these steps to mount a station on the wall.
1. Mark the mounting screw locations 2
3
/
4
inches (70
mm) apart, one above the other.
2. Drill a hole at each marked location.
3. Thread a screw into each hole until the screw’s head
extends about
1
/
8
inch from the wall.
4. Align the keyhole slots on the bottom of the station
with the screw heads, then slide the station down to
secure it.
43-492.fm Page 5 Friday, August 13, 1999 10:02 AM
To Next Page
Loading...