2
Warnings:
• To reduce the risk of injury, charge
only rechargeable Ni-Cd or Ni-MH
batteries with this charger. Other
types of batteries might burst, causing
personal injury or damage to your
charger.
• Do not charge a battery that is dam-
aged or leaking.
CHARGING BATTERIES
Notes:
• The batteries must be fully discharged
before charging.
• It is normal for batteries to become
warm while charging.
1. Plug the charger into a standard AC
outlet.
2. Lift the tab on the right side of the
charger cover and open the cover.
3. Set
Ni-Cd/Ni-MH
to
Ni-Cd
or
Ni-MH
according to the type of batteries you
want to charge.
4.
To charge two AA or AAA batteries
,
place them in the two left or right
chambers. Match the polarity symbols
(+ and –) on each battery to the polar-
ity symbols inside each chamber.
or
/9V
lights.
Note: You must charge AA and AAA
batteries in pairs.
To charge four AA or AAA batteries
,
place them in all four chambers,
matching the polarity symbols (+ and
–) on each battery to the polarity sym-
bols inside each chamber. and
/9V
both light.
Note: You can charge two AA and two
AAA batteries at the same time, but
be sure all four are the same type (Ni-
Cd or Ni-MH). Place the two AAA bat-
teries in the left chambers and the AA
batteries in the right chambers.
The charging timer begins when 2
batteries are loaded in one of the
chambers. Batteries loaded subse-
quently might not be fully charged.
To charge a 9-volt battery
, simply con-
nect it to the battery terminal in the
rightmost chamber.
/9V
lights. The
charger can only charge one 9-volt
battery at a time.
5. Close the cover. After 8 hours,
and
/9V
turn off and the charger
automatically turns off. (This prevents
overcharging high-capacity batteries.)
ILLUS
23-406.fm Page 2 Friday, August 6, 1999 2:48 PM
To Next Page
Loading...
