Radio Shack Big Digit Timer User Manual

Mounting the Clock
3
/1706+0)"6*'"%.1%-
75+0)"6*'"56#0&
You can set the clock on any level surface using the clock’s
built-in stand. Pull the stand out on the back of the clock as
far as it can go. Place the clock on the desk, shelf, or table.
75+0)"6*'"/#)0'65
The magnets on the back of the clock hold it on any metal
surface, such as a refrigerator, oven, or file cabinet. Simply
place the clock on a metal surface to mount it.
10"#"9#..
To mount the clock directly on a wall, you need two screws
(not supplied) with heads that fit the keyhole slots on the
back of the clock.
1. Drill two holes 4
9
/
16
inches (116 mm) apart.
2. Thread a screw into each hole, letting the heads extend
about
1
/
4
inch (6.5 mm) from the wall.
3. Align the clock’s keyhole slots with the screws and slide
the clock downward to secure it.
4'5'66+0)"6*'"%.1%-
If the clock displays segmented digits, does not work
properly, or locks up, you can reset it. To reset the clock,
use a pointed object, such as a straightened paper clip to
press
RESET
. The clock beeps three times. Reset the date
and time.
±
%#4'
Keep the clock dry; if it gets wet, wipe it dry immediately.
Use and store the clock only in normal temperature
environments. Handle the clock carefully; do not drop it.
Keep the clock away from dust and dirt, and wipe it with a
damp cloth occasionally to keep it looking new.
5'48+%'"#0&"4'2#+4
If your clock is not performing as it should, take it to your
local RadioShack store for assistance. Modifying or
tampering with the clock’s internal components can cause a
malfunction and might invalidate its warranty.
±"016'"±"
• Resetting the clock erases all
stored information.

Radio Shack Big Digit Timer Specifications

Power and Battery

power source	Three AAA Batteries
battery life	5000 Hours
operating temperature	32°F to 122°F (0°C to 50°C)

Weight and Dimensions

dimensions	114 × 173 × 24 mm
weight without batteries	220 g