6
CONNECTIONS
Caution:
Make all other connections before you connect the power
supply to standard AC power.
CONNECTING A DEVICE REQUIRING
POSITIVE AND NEGATIVE WIRES
1. Turn off the device requiring power.
2. Set the power supply’s POWER switch to OFF (
0
).
3. Turn the sleeves of the red and black binding output posts
counterclockwise to expose the wire hole.
4. Insert the device’s positive wire (usually red) into the red bind-
ing post’s wire hole, then tighten the binding post’s sleeve to
secure the wire in place.
22-504.fm Page 6 Friday, August 6, 1999 12:52 PM
To Next Page
Loading...
