• ATS clears all of the stat
io
ns previously set.
•
To
stop ATS, press
POWER.
To tune to a stored ATS station, just press the number key of the
stored stat
io
n.
Direct-Access Tuning
To t
un
e to a speci
fi
c frequency, fo
ll
ow these steps.
1. Press
FREQ
/
11m
. The frequency display disappears.
2. Press the corresponding n
um
ber buttons (and decimal button,
as necessary) to ent
er
the frequency.
You do
no
t need to select a band. When you key in the correct
frequency, t
he
receiver automatica
ll
y selects the appropriate
ba
nd. For exampl
e,
to enter
FM
100.70 MHz, just key in
100
.
70
.
Notes:
• If you wait more than
30
secon
ds
to press a button, the pre-
vious frequency retu
rn
s to the display and you must begin
again from Step 1 .
• If
yo
u enter an invalid frequen
cy,
E appears.
• If you make a mistake, repeatedly press c (cancel), then
enter the correct digit(s).
3. Press
ENTER.
The selected frequency appears.
21
To Next Page
Loading...
