Radio Shack DX-399 - Storing Frequencies in Memory; Storing;Arranging SW Frequencies in Memory

4. Press ENTER or the desired memory location number to store
the frequency to t
he fl ashing memory location number.
Note:
If memory is full, no memory location number flashes
and
FULL appears if you press any button. You cannot st ore a
ne w frequency, but you can replace the existi ng frequency with
the new one by
holdi ng down the desired memory location
number bu tt on for two seconds while FULL appears (be sure
you
also set the correct memory bank location).
Storing/Arranging SW Frequencies in Memory
1. Tune to the desired SW station you want to store.
2. Press
M. M and the next available memory location number
fl ash f or 15 seconds.
3.
Wh il e M and the available memory location number flash,
press
P1/P2 to select the desi red memory bank where you
want to store
SW frequencies.
4.
Wh il e Mand the available memory location number continue to
fl ash, press ENTER or the desi red memory location number.
5. Press
TUNING /\ or v . The receiver scans to the next stro n-
gest fr equency. To store this frequency in memo ry, repeat
Steps
2-4.
24
Note: If memory is full, no memory location number flashes
and
FULL appears if you press any button. You cannot st ore a
ne w frequency, but you can replace the existi ng frequency with
the new one by
holdi ng down the desired memory location
number button for two seconds while FULL appears (be sure
you
also set the correct memory bank location).