Radio Shack DX-399 - Silencing the Alarm; Turning the Alarm On or Off

4. Press ENTER. The set time ( 13: 30 , for example) appears,
and
STANDBY ~- stops flashing, indicating the radio alarm
has been set. About 2 seconds lat er , the receiver returns to the
current time.
5.
To check th e al ar m time, press STANDBY. The alarm time dis-
plays
for about 12 seconds, then disappears. If you press
STANDBY again or ENTER, th e di sp lay re t urn s to time mode.
To
cancel the alarm time, press POWER or DISPLAY so the cu rrent
time appears, then press
STANDBY. While STANDBY flashes,
press
c. t[:l and STANDBY disappear.
Silencing the Alarm
At the se t alarm time, the rad io turns on or the buzzer sounds and
~ [::I or e- flash on the display. The buzzer then stops after 30 min-
utes,
or th e receiver automatically turns o ff after 60 minutes.
To
s il ence th e alarm soon er , press POWER. The flashing t[:l or ~ ...
disappears and the alarm sounds again the next day at the set
time.
Turning the Alarm On or Off
To tu rn o ff the ala rm so it does not sound, press oc:i STANDBY or
STANDBY HWS ~ ..... (according to which ala rm you set - the radio
or the buzzer).
While t [:l STANDBY or STANDBY HWS flashes,
press
c.
To se t th e alarm to so un d again, press ~ [::I STANDBY or STANDBY
HWS ~ and then ENTER.
29