5
To charge the battery pack, place the handset on the base or charging cradle. The
CHARGE/IN USE LED (on the base) or the CHARGE LED (on the charging cradle)
should light up.
IMPORTANT: Be sure the battery pack is properly connected
before you try to charge it. The CHARGE/IN USE LED or the
CHARGE LED lights up when the handset is on the cradle, even
if the battery pack is not connected.
Recharge the battery pack when “LOW BATTERY” fl ashes on the display.
When you fi rst use the phone after charging or recharging the battery pack, the phone
might not work and you might hear error beeps. If this happens, place both handsets on
the main base successively.
Using a damp cloth, clean the charging contacts on the handsets about once a month.
About once a month, fully discharge each battery pack by keeping the handsets off the
cradle until “LOW BATTERY” fl ashes on each handset display. Otherwise, the battery pack
loses its ability to fully recharge.
Notes:
The handset should always sit in the base or charging cradle face
forward to make good contact with the cradle’s charge contacts.
If the phone does not work, recharge the battery pack. (The battery
power might be too low for the display to operate.)
If the battery pack becomes weak during a call, the handset beeps and
“LOW BATTERY” fl ashes. When this happens, you cannot make a call on
the phone until you recharge the battery pack.
If the battery pack is completely discharged or the base loses power
while the handset is away from it, place both handsets on the main base
to re-register to the main base when power resumes.
The supplied battery pack should last about a year. If the battery pack fails in less than
two hours after an overnight charge, replace it with a new 3.6V, 600 mAh battery
pack with a connector that fi ts the socket in the battery compartment. You can order
a replacement battery pack through your local RadioShack store (or online at
www.radioshack.com). Install the new battery pack and charge it for about 24 hours.
If you have trouble replacing the battery pack, take the phone to your local RadioShack
store for assistance.
WARNING:
Dispose of the old battery pack promptly and properly.
Do not burn or bury it.
There is a risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Registering Handsets
When the two handsets are removed from the packaging, the handset that is placed in the
main base unit fi rst (to charge the battery for 15-20 hours) will automatically be registered
to the main base unit. (It does not matter which handset you choose to place in the main
base unit fi rst.)
Notes:
When you charge the handsets, the Caller ID summary screen and the
name of the handset (“HS1” or “HS2”) appears.
If “HSX” appears, you are charging handset No.X.
The smaller cradle is simply an extracharging device for either handset.
You will also need to register the extra handset by placing it on the main base. The extra
handset WILL NOT operate properly until the registration has been completed. Once both
handsets are registered, they are ready for use.
Follow these simple steps to register:
1. First, install the battery packs in both handsets. Place either handset in the main
base cradle, then place the extra handset in the extra charging cradle. Charge both
handsets for 15-20 hours.
2. When fully charged, the handset in the base will be automatically registered. The LED
on the base fl ashes, indicating the registration is taken place.
3. Wait for at least fi ve seconds before removing the handset from the main base.
4. Repeat steps 2 - 3 for the other handset.
To Next Page
Loading...
