Note: By default all new objects are mapped to
Scan List 01. Refer to “Grouping Objects with Scan Lists”
on page 42 for more information on Scan Lists.
To create a new TSYS object.
1. Press
PGM to put scanner in Program Mode.
2. Press NEW softkey to create new object.
3. Press TGRP softkey to create a trunking
system object.
d
> Talkgroup <
Scan Lists: *01
TSYS: NEW
Save Exit Dflt
4. Press S or T to scroll through the talkgroup
object parameters until the cursor is at TSYS:.
5. Press SEL.
d
> Trunked System <
Type: MOT 800/900
Tag: System
Save Exit Dflt
6. The cursor should be on TYPE:.
7. Press W or X to select the desired trunking
system.
8. Press T to scroll to Tag: and enter a new
name for the system. See “Appendix C: Text EntryAppendix C: Text Entry
and QuickText” on page 125 for information on
entering text.
9. Press T to scroll to
Frequencies: to enter
the control frequencies for the system.
10. Press
SEL.
11. At
Ch01:, use the number keys and • to enter
the first control channel frequency for the
system.
12. Press T and repeat Step 11 to add any other
control channels used by the system.
13. Press the SAVE softkey to save.
14. Press SAVE softkey again to store the new TSYS
into memory and return to the TGRP menu.
d
Scan Lists: *01
TSYS: System
ID: Wildcard
Save Exit Dflt
15. Press T to scroll to ID:.
By default, the trunking talkgroup ID is set to
Wildcard.
To change the ID, press the number keys to
enter the specific talkgroup ID. Press ENT or
DONE softkey to store the ID.
See “Talkgroup Notes” below for more
information about wildcard and other
talkgroup configurations.
16. Press T to scroll down to Tag: and enter a
name for your talkgroup that corresponds
with its purpose on the trunked radio system.
See “Appendix C: Text Entry and QuickText”Appendix C: Text Entry and QuickText” on
page 125 for information on entering text.
17. Press ENT or the
DONE softkey to store the
name, then press SAVE softkey to store the
TGRP as a new object.
To Next Page
Loading...
