20
Scanner Setup
Erasing All Frequencies in a Bank
To erase all frequencies in a bank:
1. From Manual Mode, press ENT/PGM to put the scanner in Programming
Mode.
2. Press FUNC + S or T to select the bank where you want to erase all the
frequencies.
3. Press FUNC + ENT/PGM. “Edit Bank Tag or Erase All Freq.” appears.
4. Press FUNC + CL.
5. Press 1 to erase all frequencies in the selected bank. Press CL to cancel.
Or
1. From Manual Mode, press ENT/PGM to put the scanner in Programming
Mode.
2. Enter the number of the bank where you want to erase all the
frequencies.
3. Press FUNC + ENT/PGM. “Edit Bank Tag or Erase All Freq.” appears.
4. Press FUNC + CL.
5. Press 1 to erase all frequencies in the selected bank. Press CL to cancel.
Note: If you entered an invalid bank number in step 2, the scanner
displays “Invalid Bank No.” Press CL.
Copying or Moving a Frequency
To copy or move a frequency to a channel:
1. From Manual Mode, press ENT/PGM to put the scanner in Programming
Mode.
2. Select the frequency you want to copy or move. Or, directly enter the bank
and channel number and press MAN.
3. Press and hold ENT/PGM to put the scanner in Program Copy Mode.
4. Press S or T to select the bank where you want to copy or move the
frequency.
5. Press ENT/PGM. The smallest empty channel number and 0.0000
appears. If there is no empty channel, the scanner automatically selects
the first channel of the bank.
6. Press S or T if you want to select another channel, then press ENT/
PGM, “Delete Source Channel?” appears.
7. If moving a frequency, press ENT/PGM to delete the source. If copying a
frequency, press CL to keep both locations.
To Next Page
Loading...
