8
Scanner Setup
SCAN
/
• Scan the stored channels; scan an active ID while trunking.
• Press and hold to turn Signal Stalker on and off.
MAN
/
MENU
• Manually enter a channel.
• Press after FUNC to enter menu mode.
SRCH
/
TUNE
• Start a chain search; start and select a service search.
• Press after
FUNC to enter the fine tune mode and search a
specified frequency range.
TRUNK / MODE
• Enter the Talk Group ID program mode.
• Press after FUNC to select the modulation for trunking system.
WX
/
• Start weather search.
• Press and hold to activate Skywarn.
1-0
/
A-Z
Input a number or character
DIM
/
M-LOCK
• Set the display brightness.
• Press and hold to lock the memory.
ST
/
BANK
• Select options during programming; change scan or search
direction; change the ID location number while trunking.
• In Scan mode, press after
FUNC to go to select bank menu.
• In Manual or Program mode, press after
FUNC to change bank.
PSE
/
TEXT
• Stop and resume search or scan.
• Change from program mode to enter text tag mode.
•
/
DELAY
/
OPEN/CLOSE
• Enter a decimal point, space, or hyphen.
• Turn delay on or off.
• Press after
FUNC to change trunk open/close mode.
ENT
/
PGM
• Complete the entry of frequencies and text.
• Put the scanner in programming mode.
To Next Page
Loading...
