39
Automatically Storing an ID in
a Scan List Location
To store an ID in the first available
scan list location during a search,
press
E
at any time after the scanner
stops on that ID.
Or, follow these steps to store an ID in
a specific scan list location.
1. Press
PRIORITY
when the desired
ID appears.
2. Repeatedly press
▲
or
▼
to
choose a specific scan list loca-
tion.
3. Press
E
.
Note:
An ID you enter into a scan list
location automatically overwrites any
ID that is already stored in that loca-
tion.
To display a scan list location and
store an ID in that location during a
search, press
PRIORITY
to display the
current scan list location, then press
E
when your scanner stops on an ID you
want to store.
Deleting a Stored ID
1. Press
MANUAL
.
2. Repeatedly press
▲
or
▼
to select
the scan list location (shown at the
top of the display) you want to
delete.
3. Press
0
then
E
.
SCANNING THE SCAN
LISTS
Press
SCAN
to begin scanning the
lists you have programmed.
Id
SCAN
scrolls on the display.
Note:
If more than one of the scan IDs
you have stored do not work,
Error
flashes twice and the scanner beeps
several times, then the scan list num-
bers appear at the top of the display.
To remove a scan list from active
scanning, use the number keys to en-
ter the scan list’s number. The scan
list indicator turns off, and the IDs in
that list are not scanned.
Note:
You cannot remove all the scan
lists. One scan list must always be ac-
tive.
To restore a scan list to active scan-
ning, use the number keys to enter its
number again.
Press
SEARCH
to return to the previ-
ously selected function.
Priority ID Scanning
As in conventional scanning, you can
designate one ID in each scan list as a
priority ID.
To select an ID as a priority ID, hold
down
PRIORITY
for about 2 seconds
when the scanner stops on the ID.
P
appears.
20-432.fm Page 39 Friday, July 14, 2000 11:30 AM
To Next Page
Loading...
