41
Beyond the Basics
Follow these steps to select preprogrammed search
bands and search them for active frequencies:
1. Repeatedly press SRCH to select your desired search
bank (SR0, SR1, SR2, SR3, SR4, SR5, or SR6).
2. In the marine, CB, and FRS/GMRS/MURS bands,
you can directly select a channel or search through
the band. When MAN appears at the right of the
third line, you can directly select a channel (refer to
“Band Charts”). Press the desired channel number
while MAN appears to select it. You can also change
the channels by pressing e or d.
3. Press FUNC then SRCH while MAN appears. MAN
changes to SRCH and now you can search through
the band. Press FUNC then SRCH again to return to the
previous mode.
4. Rotate SQ clockwise and leave it set to a point just
after the rushing sound stops. After 2 seconds
(if the delay feature is on), the scanner starts
searching.
5. When the scanner fi nds an active frequency, it
stops searching.
To Next Page
Loading...
