73
Beyond the Basics
4. Press PROG to enter the program mode.
5. Enter the desired trunking frequency then press ENT
to store.
6. To enter additional trunking frequencies as
subsequent channels in the same bank, press PROG
or e to access the next open channel then enter
the frequencies. (See “Storing Known Frequencies
into Channels”).
7. Press SCAN to start scanning.
If you enter a frequency that has already been
entered in the current bank, the scanner sounds an
error tone and displays Dupl.Freq. and the channel
number that has been duplicated. If the dual
entry is an error press CLEAR and enter the correct
To Next Page
Loading...
