5. On the scanner that is the First Unit needs to be set as FirSt unit.
6. Press
E/PGM. The First Unit checks whether the CLONE unit is connected to correctly.
When a First Unit receives the response from the CLONE unit, the data transfer starts.
During data transfer, SND and REC flashes.
7. When the data transfer is completed,
done appears. If the data transfer is not successful, Error appears.
USING THE DISPLAY BACKLIGHT
To turn on the display light for easy viewing at night, press
.The display lights for 15 seconds. To turn off
the light sooner, press
again.
USING THE AUTO BACKLIGHT DISPLAY
You can set the scanner so the auto backlight turns on for about 5 seconds when the scanner receives signals.
If you press a key (except
) within 5 seconds, the display remains lighted for more than 15 seconds.
To turn auto backlight display on or off:
1. Press MENU.
2. Repeatedly press or to select AutoLit, then press E/PGM.
3. Repeatedly press or to select ON or OFF, then press E/PGM.
4. Press MENU to exit the menu mode.
CHANGING SEARCH SPEEDS
Note: Hypersearch applies only to the 5 kHz step bands (29–54 MHz, 137–174 MHz, and 216–224.9950 MHz).
The scanner has two search speeds.
Normal Search Hypersearch
90 steps/second 270 steps/second
TURNING THE KEYTONE OFF/ON
1. Press MENU.
2. Repeatedly press
or to display bEEP, then press E/PGM.
3. Repeatedly press or to select OFF or ON, then press E/PGM.
4. Press
MENU to exit the menu mode.
To Next Page
Loading...
