S-S.LOG: Lets you select the signal stalker logging settings.
When this option is on, scanner checks log channel along with user programmed channels.
3. Repeatedly press
or to select the option you want, then press E/PGM.
[S-S.bnd]
If you selected S-S.bnd, one of the following band names appears:
29-54 : VHF Low Band
108-137: AIR Band
137-225: VHF High Band
400-512: UHF Band
800-956: 800MHz Band
Repeatedly press
or to select the band you want to set, then press E/PGM.
[Other than S-S.band]
Proceed to Step 4.
4. Repeatedly press or to select ON or OFF, then press E/PGM.
5. When you select the option, press
・/CLR /DELAY to exit the option mode.
Using signal stalker
To turn on Signal Stalker, turn SQL fully clockwise, then press except in WX search, program search range,
or program mode. appears. Every 2 seconds, the scanner searches for frequencies in the range you
specified in “Setting the Signal Stalker Options.”
When the scanner finds a frequency, it sounds the alert you specified in “Setting the Signal Stalker Options”,
and
Found flashes. Press any key to confirm the displayed frequency. Press HOLD/RESUME to resume
scanning.
To turn on Signal Stalker and turn off normal scanning, turn
S-S.OnlY of signal stalker options to on. .
Flashes. See “Setting the signal stalker options on page XX.
To turn off Signal Stalker and turn on normal scanning, press
.. and. . disappears.
Trunking Operation
The scanner tracks transmissions that use the Motorola Type I, Type II, hybrid,
and EDACS and LTR analog trunking systems. The frequencies for many of the 800 MHz,
900 MHz, and EDACS and LTR public safety systems are listed in the separate
National Public Safety Trunked System Frequency Guide included with your scanner.
To Next Page
Loading...
