Radio Shack PRO-668 - Programming by ZIP Code

10 11
Monitoring
Monitoring simply means keeping your iScan tuned to a
single object, rather than scanning through a playlist.
The most common form of monitoring is to simply press
/II when the iScan stops on a transmission.
To return to scanning, press /II again.
You can also monitor a specific object by manually tuning
your iScan to the object.
Tomanuallytuneanobject:
1. Press MENU to access the main menu.
2. Select Browse Objects and press . The first
available playlist appears.
3. Use the direction keys to navigate through playlists
and objects.
4. Press SEL.
Priority Scanning
You may decide that a particular object should be checked
more frequently during scans. Your iScan checks Priority
objects more frequently than non-priority objects.
Note: To set priority, Priority Mode must be enabled.
ToenablePriorityMode:
1. Press MENU to access the main menu.
2. Select Settings and press SEL.
3. Select Priority Mode and press SEL . A
checkmark ( ) indicates Priority Mode is active.
4. Press MENU, and then press SEL to confirm.
Tosetpriorityobjects:
1. Press MENU to access the main menu.
2. Select Browse Objects and press SEL.
3. Use the four-direction pad to select an object and
press MENU.
4. Select Priority and press SEL . A checkmark ( )
indicates Priority.
5. Press MENU, and then press SEL to confirm.
-Settings-
Save changes
Default Vals
Simple Display
Default PL: 1
Priority Mode √
Priority
Objects
Objects
PlaylistsPlaylists
Objects
Objects
PlaylistsPlaylists
DRAFT
DRAFT