EasyManua.ls Logo

Radio Shack PRO-76 - Connecting an Earphone;Headphones; Listening Safely

Radio Shack PRO-76
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
supplied antenna. Then
route the antenna’s cable to
the scanner and connect the
cable to the scanner’s anten-
na jack.
Cautions:
Do not run the cable
over sharp edges or
moving parts that might
damage it.
Do not run the cable
next to power cables or
other antenna cables.
Warning:
Use extreme
caution when you install or
remove an outdoor anten-
na. If the antenna starts to
fall, let it go! It could con-
tact overhead power lines.
If the antenna touches a
power line, contact with the
antenna, mast, cable, or
guy wires can cause elec-
trocution and death. Call
the power company to re-
move the antenna. DO
NOT attempt to do so your-
self.
CONNECTING AN
EARPHONE/
HEADPHONES
For private listening, you can
connect an earphone or
headphones with a
1
/
8
-inch
(3.5-mm) plug to the jack
on top of the scanner. (Your
local RadioShack store car-
ries a wide selection of ear-
phones and headphones).
Connecting an earphone or
headphones automatically
disconnects the internal
speaker.
Listening Safely
To protect your hearing, fol-
low these guidelines when
you use an earphone or
headphones.
Set the volume to the
lowest setting before
you begin listening. After
you begin listening,
adjust the volume to a
comfortable level.
Do not listen at
extremely high volume
20-313.fm Page 15 Friday, January 7, 2000 3:09 PM

Table of Contents

Related product manuals