•When you enter a frequency into a channel, the
scanner automatically turns on the delay
function and DLY appears. When delay is turned
on, the scanner automatically pauses scanning 2
seconds after the end of a transmission before
scanning proceeds to the next channel. To turn
the function off or on, press FUNC + DLY.
•If you enter a frequency that has already been
entered elsewhere, the scanner sounds an error
tone and displays the channel that was
duplicated. If you entered the frequency by
mistake, press
.
/CLR then enter the correct
frequency. To enter the frequency anyway, press
E to accept.
[ To program the next channel in sequence, press
FUNC + PGM or E and repeat Steps
Y and Z.
\ To program the scanner with your local Skywarn
frequency, repeat Steps
X-Z to program Chan-
nel 200 with that frequency. For more informa-
tion, see “Skywarn” on Page 36.
To Next Page
Loading...
