direct entry search
You can use direct entry search to search up or
down from the currently displayed frequency.
X If the scanner is scanning or searching, press
HOLD.
Y Enter the frequency you want to start from by
using the number keys. (Press
.
/CLR to enter a
decimal point).
Z Press FUNC + or . The scanner searches,
starting from the frequency you entered in
Step
Y.
If you enter a frequency that is out of range, the
scanner sounds an error tone and Error appears.
Press FUNC + to change the search direction
downward or FUNC + to change the search
direction upward. Frequencies appear during the
search.
Notes:
• You can set the delay function on or off during
the search or while the search stops.
• You can skip a frequency when the search stops.
After the search skip frequency is set, the
scanner starts direct search again.
To Next Page
Loading...
