Operation
41
9:"#NGTV"CPF"$GGR"6QPG"
%QPHKTOCVKQP
1. To test the WX alert, press
WX
for more than 2 seconds while
:?=ýMNýIJ8O
:?=ýMNýIJ8O:?=ýMNýIJ8O
:?=ýMNýIJ8O
appears.
±
The display indicates the type
of message, and the scanner
sounds an alert or series of
beeps. The beeps automati-
cally change every 3 seconds.
2. Press any key except to
stop test sound mode.
75+0)"(4'37'0%;"%12;
You can copy a frequency into a
specified channel, a vacant
channel in a specified bank, or a
priority channel. However, you
cannot copy a frequency from the
Marine and CB search bands.
%QR[KPI"C"(TGSWGPE[ "KPVQ"
C"5RGEKHKGF"%JCPPGN
You can copy a frequency into a
specified channel when the
scanner stops on that frequency
during search mode or manual
tuning.
1. Press
FUNC
then
PGM
when
you find a frequency.
9^WdýIjeh[5
9^WdýIjeh[59^WdýIjeh[5
9^WdýIjeh[5
appears on the
bottom line. After about 1
second, the frequency to be
copied flashes on the
indicator.
2. Press the desired bank and
the channel number where
you want to store the
frequency. The display
indicates the bank and
channel number. After about 1
±
"016'"
±
"
• The scanner does
not display the
actual area
affected by SAME
messages. It uses
only the message
portion of the
SAME signal
(
MWhd_d]
MWhd_d]MWhd_d]
MWhd_d]
,
MWjY^
MWjY^MWjY^
MWjY^
,
IjWj[c[dj
IjWj[c[djIjWj[c[dj
IjWj[c[dj
, or
J[ijýC[iiW][
J[ijýC[iiW][J[ijýC[iiW][
J[ijýC[iiW][
).
• Your scanner can
also receive
weather alert
tones (see
“Priority” on
Page 47). The
scanner sounds
an alert or beep
when it receives
the SAME code. If
you do not stop
the alert, it sounds
the alert (or beep)
for five minutes.
Then the alert
stops and the
scanner beeps
every ten
seconds. If the
scanner receives
a new message
after five minutes,
it sounds the alert
or beep. To stop
the sound and
ready the scanner
to receive a new
alert signal before
the five minute
time out, press
any key except
.
20-525NEW.fm Page 41 Monday, July 1, 2002 2:58 PM
To Next Page
Loading...
