Radio Shack REALISTIC PRO-2042 - Moving Frequencies Within Banks; Moving Frequencies from Banks to Monitor Memories

If you select a bank that does not
contain any empty channels, a bar
flashes under the bank number,
and A-FULL and AUTO appear. To
store new frequencies into this
bank, you must delete one or more
frequencies stored in it, then repeat
Step 2. See “Deleting Frequencies”
on Page 29.
3. Press and hold down ENTER, then
press MONITOR. A bar flashes
under the bank number, and AC-,
the number of empty channels in
the bank, Ch, and auto appear.
The scanner moves all frequen¬
cies stored in monitor memories
into the bank you specified in Step
2 .
Moving Frequencies Within
Banks
You can move all stored frequencies
within a bank from higher channels to
lower, empty channels. This helps you
group all of the frequencies you stored
in a bank into consecutive channels.
For example, if you stored frequencies
in channels 1 through 25, left channels
26 through 30 empty, then stored more
frequencies in channels 30 through 40,
the scanner can move all the frequen¬
cies together into channels 1 through
35.
1. Press AUTO. AUTO appears.
2. Using the number keys, select the
bank’s number.
3. Press and hold down ENTER, then
press RESET. The scanner auto¬
matically moves all frequencies in
channels within the bank in con¬
secutive order to the lowest avail¬
able channels within the bank.
Moving Frequencies from
Banks to Monitor Memories
You can move all stored frequencies
within a bank to monitor memories.
This lets you quickly clear channels
within a bank without losing the fre¬
quencies.
Caution: If you move frequencies from
a bank to monitor memories, all fre¬
quencies already in the monitor me¬
mories are replaced with those fre¬
quencies and any empty channels
from the bank.
1. Press AUTO, auto appears.
2. Using the number keys, select the
bank’s number.
3. Press and hold down ENTER, then
press . (decimal). The scanner
automatically moves all frequen¬
cies in channels within the bank to
monitor memories.
28