Radio Shack Regulated Power Supply - Operation and Specifications; Operating the Power Supply

10
OPERATION
To use the power supply after you connect the device to it, set
POWER
to
ON
to turn it on.
Note:
If the power supply’s
POWER
switch does not light:
• Check all connections and confirm the AC outlet has power.
• If the outlet has power, set
POWER
to
OFF
, reduce the load (by
using a device that does not require more than 13.8V DC),
then set
POWER
to
ON
. Your power supply’s overload protec-
tion circuit automatically shuts down the power supply when it
is overloaded and resets by turning the
POWER
switch to
OFF
.
22-506.fm Page 10 Friday, August 6, 1999 12:55 PM