FLOPPY/OCT
If
you attempt
to
re-install Memdisk
in
a different area of memory than
the area that it was originally installed
in,
you
get the error message
"MemDISK already Active." Memdisk must always
be
re-installed
as
it
was initially installed.
If
you specify the wrong drive number
(in
the SYSTEM (DRIVE =
drive,DRIVER = "MEMDISK") command)
and
you
attempt to disable
the Memdisk, then you receive the error message "Target Drive not a
MemDISK."
If
you attempt
to
disable a Memdisk
and
there
is
no
MemDISK
in
the
system to disable, then
you
receive the error message "MemDISK not
present."
Technical Information
A Bank 0 Memdisk
and
BASIC use the same area of memory (RAM).
Since a Bank
0 Memdisk
and
BASIC use the same area of memory,
we recommend that
you
do
not use BASIC when Memdisk is resident
in
Bank
0.
If
you are going
to
use Memdisk
as
the system drive, you must
COpy
SYS0/SYS to it before it becomes the system drive. After Memdisk
becomes the system drive,
you
can
REMOVE SYS0/SYS from the
Memdisk.
Driver I
FLOPPY/DCT
is
used
in
Radio Shack hard disk installations. See
your hard disk manual for
an
explanation
on
how
to
use this driver.
A-99
To Next Page
Loading...
