remove the TRSDOS system diskette from Drive 0 and set it
aside.
Remove the write-protect tab (if any) from the master backup
limited diskette you want
to
copy. This will
be
the SOURCE
diskette.
Place the backup limited diskette
in
Drive 0 and press
(ENTER).
5.
The following message may appear:
Destination
disK
NarTle=disflnafrlE
Are
YOU
sure
}'OU
it
<YIN> ?
ID
is
different:
Date=frIfr1/ddl>'Y
want
to
bacKup
to
Respond
by
typing
rn
(ENTE]).
6.
The computer now performs the backup. When you see the
prompt:
Insert
SYSTEM
disK
<ENTER>
remove the backup limited diskette from Drive 0 and place a
write-protect tab
on
it.
Remove the new backup copy from Drive
1.
Place a write-protect
tab
on
it and place a label
on
the jacket to identify
it.
Insert the TRSDOS system diskette
in
Drive 0 and press
(ENTER).
A message is displayed telling you if the backup operation was
successful or not. If there was
an
error, start over with step 1
using another blank diskette. Unsuccessful backups do not count
against the number of backups you can make.
For
systems
with
one
floppy drive:
(If you have a hard disk system and one floppy drive, start up as a
floppy disk system and use this procedure.)
1.
Insert a TRSDOS system diskette
in
the drive.
2.
At TRSDOS Ready, type the following command:
FORMAT
: 0 (Q=N)
(ENTER)
3.
When you see the prompt:
Load
destination
diskette
<ENTER>
remove the TRSDOS system diskette from the drive and insert a
blank diskette. Press
(ENTER).
4.
When you see the prompt:
Load
SYSTEM
disKette
<ENTER>
A-110
To Next Page
Loading...
