remove the formatted diskette and insert the TRSDOS system
diskette. Then press
(ENTER).
If
the disk has any flaws
on
it (that
is,
if
an
asterisk is displayed
next
to
one or more cylinder numbers), repeat steps
2,
3,
and 4
using another blank diskette. Remember that you can make only
a fixed number of copies of this diskette, so you should try to use
good media.
5.
At TRSDOS Ready, type:
BACKUP
:0 :0
(ENTER)
6.
When you see the prompt:
Insert
SOURCE
disk
<ENTER>
remove the TRSDOS system diskette from the drive and set it
aside.
Remove the write-protect tab (if any) from the backup limited
diskette
you
want to copy. This will be your SOURCE diskette.
Insert the backup limited diskette
in
the drive and press
(ENTER).
7.
When you see the prompt:
Insert
DESTINATION
disk
<ENTER>
remove the backup limited diskette from the drive and insert the
blank diskette. Press
(ENTER).
8.
The following message may appear:
Destination
disf,
NalTle=disf,nafTIe
Are
YOU
sure
YOU
it
<Y,N> ?
ID
is
different:
Date=fTllrI/dd/yy
want
to
backup
to
Respond by typing
CY)
CENTER).
9.
You are asked
to
insert the SOURCE and DESTINATION disks
several times.
Be
very careful that you do not mix them up!
Simply follow the instructions
in
steps 6 and 7 each time you see
one of the two messages.
10. When
you
see the prompt:
Insert
SYSTEM
disk
<ENTER>
remove the limited backup diskette from the drive and place a
write-protect tab
on
it.
Place a write-protect tab
on
the new
backup copy and place a label
on
the jacket to identify
it.
:i
Isert the TRSDOS system diskette
in
the drive and press
(ENTER).
A message
is
displayed telling you if the backup
operation was successful or not. If there was
an
error, start over
A-111
To Next Page
Loading...
