2/Setting
Up
the
Modem
II
Set
your Modem's
POWER Switch to OFF
before
connecting anything!
There
are three steps
to setting up your
modem. Each
step is fully
explained in this section.
•
Connect your
Modem II to your
telephone.
•
Connect your
Modem II to a power
supply.
®
Connect your
Modem II to a
computer.
Connecting
the
Telephone to
the
Modem
II
The way you
connect the Modem II to a
telephone
depends on
how your telephone is connected
to
the wall. The
following three
figures illustrate
these connections.
If
you're using your
Modem II outside
the USA, you may
need a
Modular-to-Modular Cable
(Radio Shack
Catalog Number
279-374)
and a Duplex Modular
Jack (279-357).
Figure
3. Modular Connector
If your
telephone has this type of
connection, attach your Modem II as shown. (If you plan
on
using the
Modem in AUTOmatic Modes
only, you don't need to use a telephone.)
To Next Page
Loading...