Radio Shack TRS-80 Voxbox - Page 11

Running the Application
Programs
Inventory
Program
This
program illustrates
howdata may
be
entered using
the
VOXBOX.
It
also illustrates
use of a
keyword
to start a command
or data
sequence.
Such keywords
or "wake-up" words
are useful
to minimize
interference
from
background noise.
These program control words are used in this
demonstration:
"PART'
To begin
the data entry
sequence at the
part number.
"QUANTITY"
To end the part number
and begin
entry
of the quantity of
that part.
"BACKSPACE"
To
allow
the previous entry
to be
corrected (re-entered).
"SCRATCH"
To
cancel
a
complete
sequence
and begin
over again with the
word "PART'.
"OK"
To accept an entry after visual
verification.
"SAVE"
To
signal
the end of the
entry program.
After
training the
system you may enter part numbers
and quantities
by
entries of the
following form:
PART
(digit)(digit)
. . .
QUANTITY (digit)(digit)
... OK
For
example:
PART 123
QUANTITY 45
OK
"OK" signals
the system to
enter
this
data.
If
you or the
system makes
an error,
you can say
BACKSPACE to erase digits.
You
can also say
SCRATCH to
clear the
entire entry. In the part field
the letters
A or
B,
or the
character
"-"
(dash), may also be used to make
up the
part
number.
When you are
through trying the
Inventory
demo, say
SAVE instead
of
PART
to
end the program. In this
demonstration,
data
is
not
actually
saved at
this point.