Radio Shack TRS-80 Voxbox - Page 5

Setting
Up
1.
Setting
Up
Connecting
the
VOXBOX
to the TRS-80
(See Figure
1.)
1.
Turn off
the TRS-80; leave the VOXBOX
unplugged.
2.
Remove the curved
hood on the left rear
of
the TRS-80,
exposing
the TRS-80
card edge. Connect the VOXBOX
cable to this
card-
edge, with
the ribbon cable exiting
from the
bottom
of the
connector.
3.
Plug the
microphone into the DIN
jack on the
front
of the
VOXBOX. Take care to make the correction
properly.
4.
Connect the
power-supply mini-plug into
the
back of
the
VOXBOX.
5.
Plug the VOXBOX power supply into a
source of
120 VAC.
6.
Follow
the power-up instructions below.
REMOVE
DOOR OVER TRS-80 CARD
EDGE
CONNECT VOXBOX
CONNECTORIZED
CABLE
WITH CABLE EXITING
BOTTOM
OF CONNECTOR
PLUG POWER UNIT IN
HERE
VOXBOX POWER UNIT
PLUG INTO 120 VAC
OUTLET
POWER
ON/OFF SWITCH
(IN=ON)
MICROPHONE DIN
CONNECTOR
1 1 1 1 1 1 1 1 1 1 1 1 1 1
1 1 1 1 1 1 1
1 1 1 1 1 1 1 1
1 1 1 1 1 1 1 1 1 1 1 1
1
VOXBOX
TRS-80
TOP VIEW
CONNECTING
VOXBOX
TO YOUR
TRS-80
FIGURE
1