BH7NOR & BG6QBV Firmware and software downloads：http://avrx.cn
- 17 -
connect the AVRT7 plus to a external antenna
DC IN (7~12V)
LCD screen socket ( optional LCD screen)
USB-TTL socket
RJ45 network socket ( 568A/568B self-adaptable, DHCP IP address
automatically obtaining.)
External radio socket ( 6 pins cable could be connected such as FT8800R,
IC2720H,etc.)
External RF antenna base.
(screen cable)： 8 pins newwork cable is available
1. The LCD must be connected to the system only before AVRT7 plus is
turnned on, then reboot it.
2. The ordinary 1:1, 8 pins RJ45 network cable is available for the system
screen. A shielded cable is recommended to avoid the outer
interference.
3, LCD screen for the built-in and external radio beacon are displayed,
such as receiving beacons at the same time the external radio priority
display.
To Next Page
Loading...