17 18
Menu No. Menu Selection Description & Default settings
Default: OFF
CTCSSS /DCS: Channel Busy and lock. When the radio receives a
matched carrier, transmission is prohibited.
OFF: Always allow transmitting no matter what status of receiving
REPEATER: Signaling Busy and lock. When the radio receives a
matching carrier, but CTCSS/DCS does not match, the transmission
is prohibited.
BUSY: Channel Busy and lock. When the radio receives a matched
carrier, transmission is prohibited.
Default: Current channel name
You can edit the name for the current channel.
When you in the CHANNEL NAME menu, press 1 on the mic to
select the place of the character in sequence, then press
DN
or
UP
on the mic to select the letter or number. The max characters are
8.(a-z, A-Z, 0-9)
*Note: Only available in Channel Mode
Default: OFF
Prohibit the current channel to transmit
CTCSSS /DCS
OFF
REPEATER
BUSY
--------
a-z
A-Z
0-9
11 RPLOCK
12
CHANNEL
NAME
13
TX
INHIBIT
Menu No. Menu Selection Description & Default settings
Default: OFF
TX Noise Compander
Compander function will filter the background noise to enhance audio
clarity, especially in long range communication.
Recommend turn on this function when the signal is weak.
Default: OFF
RX Noise Compander
Block some background noise while receiving, it is obvious when the
signal is weak.
Recommend turn on this function when the signal is weak.
See the Menu 04
Enable to select the group you pre-programmed.
See the Menu 04
Enable to select the group you pre-programmed.
Default: FREQ
The content display at the place of sub-channel
OFF: The sub-channel is empty.
VOLT: Display the current volt
FREQ: Display the current frequency
ON
OFF
ON
OFF
1-100
1-32
OFF
VOLT
FREQ
15 COMP
16 NC
17 5TONE
18 2TONE
19 DSPSUB
To Next Page
Loading...
