07 08
7. SPECIFICAITONS
If your radio seems to be malfunctioning because of
wrong operation or setup, this function will resume all
setup and channels to factory default.
1. Press front panel key to enter main MENU list.
2. Press or key to chooe 30th function, the LCD
display reset options.
3. Press key to chooe “FACTORY？”
4. Hold key, until the radio re-power on.
After reset, all channel and fucntion setting will resume
default value.
6.3 Reset Factory Default
No.
17
18
19
20
21
22
23
24
25
26
27
28
29
30
Function name
5 Tone
2 Tone
Sub channel display
Key beep
Time out timer
DMTF transmit time
Squelch level
Scan pause time
LCD brightness
VOX level
VOX delay
Tone burst frequency
Channel display
Reset
Setting value
1~100,
Press PTT to transmit
1~32,
Press PTT to transmit
FREQ、VOLT、OFF
ON、OFF
1~30Min、OFF
50ms~500ms
OFF、1~9
5ST、10ST、15ST、2SP
1~5
OFF, 1-9
0.5-5 Second
1750Hz, 2100Hz
1000Hz, 1450Hz
FREQ, CH, NAME
FACTORY？ INITIALIZE？
Frequency Range
Channel Spacing
Channel Number
Operating Voltage
Squelch
Frequency Stability
Operating Temperature
Dimensions(mm)
Weight
Sensitivity (12dB Sinad)
Adjacent Channel Selectivity
Audio Response
Hum & Noise
Audio distortion
Audio power output
≤ 0.25μV
≥ 70dB
+1~-3dB(0.3~3KHz)
≥ 45dB
<3%
>2W@10%
≤ 0.35μV
≥ 60dB
+1~-3dB(0.3~2.55KHz)
≥ 40dB
TX1: 462.5625-462.7125MHz (5W)
TX2: 462.550-467.725MHz
RX: 136-174MHz, 400-480MHz 65-108MHz
12.5K/25K
500 channels
DC 13.8V±15%
Carrier/ CTCSS/DCS/5Tone/2Tone/DTMF
±2.5ppm
-20℃ ~ +60℃
124x101x36m
0.45kg (main unit)
/
If choose“INITIALIZE？”, only function setting value
will resume to default setting.
GENERAL
RECEIVER
Wide band Narrow band
To Next Page
Loading...
Need help?
General
