RadioLink AT9S PRO - 3.3.5 AILE DIFF (ACRO; GLID 2 A+1 F; GLID 2 A+2 F)

42
Other samples:
• RUD-ELEV (ACRO GLID) mix: Compensate for pitching up or down when rudder is applied.
• AIL-RUD mix (ACRO): Coordinate turns by applying rudder automatically with aileron input. All model types.
• ELEV-PIT (HELI) mix: Compensate for the loss of lift of tilting the model
Curve Programmable Mixes (PROG.MIX5-8)(HELI: PROG.MIX5-6 ):
AT9S Pro’s ACRO/GLID programs contain four separate curve programmable mixes. HELI contains two.
There are a variety of reasons you might want curve mixes. Usually a linear mix doesn't fit your needs along
the whole range. One pre-programmed curve mix is the THROTTLE-NEEDLE function. This curve is
adjustable at 5 points, allowing you to adjust the motor’s tuning at 5 points along its RPM range.
One programmable curve mix defaults to RUDDER-AILERON. A linear mix that keeps the model from rolling
in knife-edge is probably too much aileron when rudder is applied in level flight. Create a curve mix and set all
5 points to match the linear mix. Inhibit the linear mix, and then adjust the curve to get the right response all
along the rudder channel’s travel.
Adjustability:
• ACRO/GLID Defaults: The 4 programmable curves mixes default to the most frequent choices, but can be
set to any channel.
• PROG.MIX5 rudder-to-aileron for roll coupling compensation (GLID mixes default to aileron-to-ELEV.)
• PROG.MIX6 rudder-to-aileron for roll coupling compensation (GLID mixes default to aileron-to-ELEV.)
• PROG.MIX7 rudder-to-elevator for pitch coupling compensation (GLID mixes default to
elevator-to-airbrake.)
• PROG.MIX8 rudder-to-elevator for pitch coupling compensation (GLID mixes default to
elevator-to-airbrake.)
Optional: set switch to STK-THR to
activate mix with THROTTLE
STICK.
to SW ,PUSH to STK-THR
to POSI， Throttle Stick to desired
point .
Push 1sec.to set.
Optional: set switch position to
NULL. Make mix active at all time.
Not complete with STK-THR.
to POSI, PUSH, to NULL
Set rate. (Ex: Lo=0%,Hi=5%)
to RATE ,PUSH VR(A)， leave at
0%， VR(A)past center . to 5%
Set OFF SET, if needed.（Ex：0）
to OFST to 0%
Close