RadioLink R8FG - RadioLink R8 FG Specifications and Installation Guidance; R8 FG Receiver Technical Specifications; Antenna Installation Best Practices

RadioLink Electronic Ltd
www.radiolink.com
9
5.4 Gyro Sensitivity Adjustment
Gyro sensitivity is defaulted to adjust by channel eight that default controlled by DL1/PS3 knob switch,
turning the DL1/PS3 knob switch clockwise to increase sensitivity and anti-clockwise to reduce it. When
turning the DL1/PS3 knob switch, a tooltip with yellow background color will pop out at the top of the
screen, and the value of the channel will be changing at the same time, the value is closer to +100, the
higher sensitivity. If the value is 0, it means the gyro function has been turned off.
You can also assign other switches to control the gyro function or adjust the sensitivity on this page.
6. R8FG Specifications
7.
Note of Antenna Installation
In order to maximize the signal transmission, it’s greatly advised that
1. Keep antennas as straight as possible, or the effective control range will reduce.
2. Keep the two antenna in 90° angle as shown below
R8FG Receiver
Dimensions
L*W*H =35*24*13.5mm (1.38"*0.94"*0.53")
Weight
10.5g(0.37oz)
Channel
8 channels
Control Distance
Ground 600 meters (1968.5ft) (Maximum range tested in unobstructed areas
free of interference)
Operating Current
30mA
Operating Voltage
3-12V
Signal Output
SBUS&PPM&PWM
Telemetry
Real-time built-in telemetry of model battery voltage, RSSI, and receiver
voltage
Water Splash Proof
The waterproof grade is IPX4
Gyro
Receiver with gyro integrated, customizable gyro sensitivity
Compatible
Transmitter
RC8X, RC6GS V3, RC6GS V2, RC6GS, RC4GS V3, RC4GS V2, RC4GS,
T8FB, T8S